Cleaning And Maintenance; Troubleshooting - Gorenje SGT 2400 MV PRO Instruction Manual

CLEANING AND MAINTENANCE

1.Disconnect the power cord from the mains supply outlet.
2.Use a damped cloth or non-scratching cleaner to remove the deposits on the sole
plate or the cabinets.
3.Never use sharp or rough objects to remove the deposit on the sole plate.
4.Never use any abrasive, vinegar or descaling agents to clean the iron.
Warning
If you live in an area with hard water (over 7dH), fast scale and minerals build up will occur. It is
therefore recommended to use distillated water !
Malfunctioning appliance associated with scale and minerals build up are not subject of garantee
interventions.
STORAGE
1. Make sure the water is already drained out from the water tank
2. Place the iron unit on the base.
3. Turn the carry lock to the lock position
4. You can carry the appliance with one hand by the handle of the iron
unit when the iron is lock on the base.
HINT FOR IRONING
1. Sort out the articles to be ironed according to the type of fabric. This will minimize
the frequency of temperature adjustment for different garment.
2. If you start ironing at a high temperature and then select a lower one, the soleplate may
take more than two minutes to cool down. To speed up the cooling process, you may
press the steam trigger.
3. Test ironing a small area on the backside or inside the garment if you are unsure
about the type of fabric. Start with a low temperature and increase gradually.
4. Wait for 2 minutes before ironing the heat sensitive fabrics. Temperature adjustment
needs certain time to reach the required level, no matter it is higher or lower.
5. Delicate fabrics such as silk, wool, velour, etc. are best ironed with an ironing cloth to
prevent shine marks.
TROUBLE-SHOOTING
If your steam station does not work well, check the following points:
Problem
The unit does not
work
No steam coming out
when pressing the
steam trigger
Sole-plate doesn't
heat well
Damage textile
Loud noise
Cause
There is under heat up
It is not plugged in
The anti-scale cartridge is
not installed/ installed improperly
Socket doesn't work
Water tank empty
The appliance is still
heating up
Steam ironing is not
available
Incorrect Fabric setting
Over heat
First time use
Water tank empty
Solution
Wait for heating up
Plug in
Install the scale cartridge properly
Plug in other good socket
Fill water tank
Wait for heating up
Press the function button for a higher
temperature setting
Press the function button for a higher
temperature setting
Follow the garment guide or test on
the inside of the hem of the garment.
It is normal
Fill water tank
47