JVC TH-A10 Service Manual page 8

TH-A10
Removing the DVD servo control board
Prior to performing the following procedure,
remcover and the right side cover.ove the top cover,
the rear
1. Remove the three screws G and pull the DVD servo
control board case upward.
2. Disconnect the harness from connector CN501 and
CN503, and the card wire from CN101, CN103 and
CN502 of the DVD servo control board on the
underside of the DVD servo control board case.
3. Remove the four screws H attaching the DVD servo
control board.
1-8
(See Fig.15 to 17)
DVD servo control board case
DVD servo control board case
Analog I / O board
Digital I / O board
CN681
CN687
DVD servo control board (case)
Fig.15
CN503
CN501
CN103
Fig.16
DVD servo control board
H
Fig.17
CN201
G
CN502
CN101
H
H
H