JVC TH-A10 Service Manual page 16

TH-A10
Removeing the loading mechanism parts
(refer to Figures 10 - 11)
o Remove the clamper base.
o Remove the disk tray.
1. Turn the lever counterclockwise until it stops (position 1),
while pushing the switch lever in the direction of the
arrow and pushing up the pawl at A using a screwdriver.
2. Stretch the two pawls at B outward using a screwdriver
and remove the chassis.
3. Turn the lever clockwise (position 2) to remove the
up-down cam.
4. Remove the pulley gear and the pulley gear belt after
removing the screw at G fixing the pulley gear.
5. Pull out drive gear 2 then drive gear 1.
Removing the loading motor board
(refer to Figures 11 - 12)
o Remove the clamper base.
o Remove the disk tray.
1. Remove the loading belt.
2. Remove the two screws at H fixing the loading motor.
3. Remove the screw at I and the three pawls at C fixing
the loading motor base from the reverse side of the
loading base.
1-16
Up-down cam
Pawl B
G
(1)When detaching
the chassis.
chassis.
G
H
Loading motor unit
H
Loading base
Loading belt
Loading base
Loading base
Lever
2
1
Switch lever
(2)When detaching
the up-down cam.
Up-down cam
Up-down cam
G
Figure 10
Drive gear 1
Drive gear 2
G
Pulley gear
Figure 11
Loading motor board
I
Pawl C
Figure 12
Pawl A
Chassis
Pawl B
Switch lever