JVC TH-A10 Service Manual page 17

Disassembly method
<Speaker>
Removing the amplifier assembly
1. Remove the twelve screws A attaching the amplifier
assembly on the back of the body.
2. Move the amplifier assembly backward and
disconnect the harness from connector CN109 in the
lower part of the amplifier assembly.
Removing the heat sink cover and the
amplifier cover (See Fig.2 and 3)
Prior to performing the following procedure, remove
the amplifier assembly.
1. Pull out the volume knob.
2. Remove the four screws B attaching the heat sink
cover.
3. Remove the twenty screws C and the one screw D
attaching the amplifier cover.
(See Fig.1)
CN109
Volume knob
Amplifier
cover
C
A
A
A
Fig.1
Fig.2
C
C
D
C
C
Fig.3
TH-A10
Amplifier
assembly
A
B
Amplifier
assembly
Heat sink
cover
B
Amplifier
assembly
C
Amplifier
cover
C
1-17