Rf Safety Notice; Safe Compass Distance; Water Ingress - Raymarine AIS 350 Installation Instructions Manual

Warning: Switch off power supply
Ensure the vessel's power supply is switched OFF
before starting to install this product. Do NOT connect
or disconnect equipment with the power switched on,
unless instructed in this document.
Warning: Ensure all equipment has
isolated power supply
This product features an isolated power supply. To
prevent potential damage to equipment, Raymarine
recommends that any external equipment connected
to this product also features an isolated power supply.
Warning: Ensure safe navigation
This product is intended only as an aid to navigation
and must never be used in preference to sound
navigational judgment. Only official government
charts and notices to mariners contain all the current
information needed for safe navigation, and the
captain is responsible for their prudent use. It is the
user's responsibility to use official government charts,
notices to mariners, caution and proper navigational
skill when operating this or any other Raymarine
product.
Caution: Power supply protection
When installing this product ensure the power source
is adequately protected by means of a suitably-rated
fuse or automatic circuit breaker.
8
Caution: Service and maintenance
This product contains no user serviceable
components. Please refer all maintenance and repair
to authorized Raymarine dealers. Unauthorized repair
may affect your warranty.

RF safety notice

RF radiation statement
AIS transceivers generate and radiate radio frequency (RF)
electromagnetic energy (EME).

Safe compass distance

Safe compass distance is 1 meter minimum for any compass. Some
compass types may require greater distances. To be sure, you
should locate your AIS unit as far as possible from the compass.
Test your compass to verify proper operation while the AIS unit is
also operating.

Water ingress

Water ingress disclaimer
Although the waterproof rating capacity of this product meets the
stated IPX standard (refer to the product's Technical Specification),
water intrusion and subsequent equipment failure may occur if
the product is subjected to commercial high-pressure washing.
Raymarine will not warrant products subjected to high-pressure
washing.
AIS350 / AIS650