Chapter 1 Important Information; Disclaimers; Rf Exposure; Compliance Statement (Part 15.19) - Raymarine AXIOM PRO Installation Instructions Manual

Chapter 1: Important information
Warning: Product installation and operation
• This product must be installed and operated in accordance with the instructions
provided. Failure to do so could result in personal injury, damage to your vessel
and/or poor product performance.
• Raymarine recommends certified installation by a Raymarine approved installer.
A certified installation qualifies for enhanced product warranty benefits. Contact
your Raymarine dealer for further details, and refer to the separate warranty
document packed with your product.
Warning: High voltage
This product contains high voltage. Adjustments require specialized service
procedures and tools only available to qualified service technicians. There are
no user serviceable parts or adjustments. The operator should never remove the
cover or attempt to service the product.

Disclaimers

Raymarine does not warrant that this product is error-free or that it is compatible with products
manufactured by any person or entity other than Raymarine.
This product uses digital chart data, and electronic information from Global Navigation Satellite
Systems (GNSS) which may contain errors. Raymarine does not warrant the accuracy of such
information and you are advised that errors in such information may cause the product to malfunction.
Raymarine is not responsible for damages or injuries caused by your use or inability to use the
product, by the interaction of the product with products manufactured by others, or by errors in chart
data or information utilized by the product and supplied by third parties.
This product supports electronic charts provided by third party suppliers which may be embedded or
stored on memory card. Use of such charts is subject to the supplier's End-User Licence Agreement.

RF exposure

This equipment complies with FCC / ISED RF exposure limits for general population / uncontrolled
exposure. The wireless LAN / Bluetooth antenna is mounted behind the front facia of the display.
This equipment should be installed and operated with a minimum distance of 1 cm (0.39 in) between
the device and the body. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter, except in accordance with FCC multi-transmitter product procedures.

Compliance Statement (Part 15.19)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.

FCC Interference Statement (Part 15.105 (b))

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
Important information
9