Christie Q Series Safety Manual page 6

Safety Precautions (continued)
CAUTION
Be careful in moving the projector.
Failure to do so could result in personal injury or physical damage.
• Do not move the projector during use. Before moving, disconnect the
power cord and all external connections, and close the slide lens door or
attach the lens cap.
• Avoid any impact or shock to the projector.
• Do not drag the projector.
• For moving the projector, use the enclosed case or bag if provided.
Do not put anything on top of the projector.
Placing objects on the projector could make the projector off balance, fall
off and cause personal injury or physical damage. Use special caution in
households where children are present.
Do not attach any parts that are not specified in the manual of this
product.
Failure to do so could result in personal injury or physical damage.
• Some projectors have a screw thread in a lens part. Do not attach any
parts other than specified options (such as conversion lens) to the screw
thread.
Avoid a smoky, humid or dusty places.
Placing the projector in a smoke, a highly humid, dusty place, oily soot or
corrosive gas could result in fire or electrical shock.
• Do not place the projector near a smoky, humid or dusty place (for
example, a smoking space, a kitchen, a beach or the like). Do not place the
projector outdoors.
• Do not use a humidifier near the projector.
Take care of the air filter to normal ventilation.
The air filter should be cleaned periodically. If the air filter becomes clogged
with dust or the like, internal temperature rises and could cause malfunction.
The projector may display a message "CHECK THE AIR FLOW" as the
internal temperature is rising. Turn the power off if you see this message.
• When the indicators or a message prompt you to clean the air filter, clean
the air filter as soon as possible.
• Replace the air filter if it is excessively soiled or damaged.
• Use the air filter of the specified type only. Contact your dealer for a
replacement specified in these manuals.
• When you replace the lamp, also replace the air filter as well.
• Do not turn on the projector without the air filter attached.
Avoid a high temperature environment.
Heat could have an adverse influence on the cabinet of the projector and
other parts. Do not place the projector, the remote control and other parts in
direct sunlight or near a heat source such as heater, and so on.
Avoid Magnetism.
It is recommended avoiding any magnetic contact that is not shielded or protected
on or near the projector. (That is. magnetic security devices, or other projector
accessory that contains magnetic material that has not been provided by the
manufacture, and so on.) Magnetic objects may interrupt the projector's mechanical
performance and interfere with the motion of cooling fans, which could result in the
projector to shut down.
020-000859-01 Rev. 1 (12-2015)
DWU1052/DHD1052
LIT GUID SAFE DWU/DHD1052
Safety Guide
5