Maintenance And Error Alerts - Honeywell PM42 User Manual

Maintenance and Error Alerts

Use this table to find solutions to some common maintenance and error
alerts.
Maintenance and Error Alerts
Alert
Label Not Taken
Printhead Lifted
Out of Ribbon
Out of Media
Ribbon Low
Media Low
Ribbon Installed
Printer in Pause
Mode
Printer in Menu
Mode
Application Break
Print Job Complete A print job has been successfully completed.
Odometer (Printer) The printer has reached a limit set in the Odometer
Odometer
(Printhead)
PM42 Industrial Label Printer User Manual
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Solution
Printing has been stopped because a label is
obstructing the label taken sensor. Remove the
label to resume printing.
Lower the printhead.
Load ribbon in the printer.
Load media in the printer.
The diameter of the remaining roll of media is
lower than the specified value in the Ribbon Low
Diameter setting. Replace the ribbon.
The diameter of the remaining roll of media is
lower than the specified value in the Media Low
Diameter setting. Replace the media.
The printer is configured as a direct thermal printer
and thermal transfer ribbon is installed. Remove
the ribbon or configure the printer for thermal
transfer media.
A print job is paused from the front panel. Press
the Print button to resume printing.
A user entered a menu from the front panel. Press
the Menu/Home button to return to the Ready
screen.
(Fingerprint only.) An application breaks
uncontrolled.
(Printer) setting in Maintenance Alerts for the
amount of media to print before being alerted.
The printhead has reached a limit set in the
Odometer (Printhead) setting in Maintenance
Alerts for the amount of media to print before being
alerted.
V10 CONSUMIBLES S.L.
Chapter 5 — Troubleshoot the Printer
53