Table of Contents
Advertisement
4 Route the ribbon through the print mechanism and pull out
5 Turn the ribbon takeup hub counterclockwise until the ribbon
6 Load media.
7 Turn the printhead lift lever clockwise to lower the printhead.
8 Close the media cover.
9 Press the Print button to advance the media.
10 Configure the printer for the correct media type: media with gaps,
11 Set the print method to ribbon (TTR).
12 Calibrate the sensors:
PM42 Industrial Label Printer User Manual
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
approximately 20 cm (8 inches) of ribbon leader.
The dashed line shows how to load ribbon with the ink wound in.
becomes tight and runs wrinkle-free through the print mechanism.
black mark, continuous fixed length, or continuous variable length.
•
From the printer Main Menu select Wizards > Calibration >
Media.
•
From the printer web page select Services > Media Calibration.
V10 CONSUMIBLES S.L.
Chapter 2 — Set Up the Printer
21
Advertisement
Table of Contents
