Racelogic VBOX 3i Manual page 7

Once the VBOX3i has downloaded the new almanac it will reacquire satellites in noisy situations (such as near trees,
buildings and under bridges) much quicker. It will also acquire satellite much quicker on power-up.
To perform a GPS coldstart on the VBOX3i perform the following actions:
1. Press and hold the
2. When the button is released the
and the GPS engine is now not locked onto any satellites.
3. After approximately 30 – 45 seconds, the
has been achieved and indicating the number of satellites that it is locked onto.
Important notes
When a GPS coldstart is carried out, please note that this resets the DGPS and RTK mode to 'None'. Also, if using a
dual antenna system, the VBOX 3iSL will reset dual antenna separation to default settings (1 m).
'LOG' button on the front of the VBOX 3i for five seconds until a long beep is sounded.
'SATS' LED
'SATS' LED
will start to flash red showing that the coldstart has been performed
will start to flash green / orange indicating that satellite lock
7