Eaton Char-Lynn 2000 Series Parts And Repair Manual page 6

2000 Series Disc Valve Motors
Disassembly
Valve Drive
Figure 6 (A) .
10. (A) Remove the valve plate.
11. (A) Remove the 76,0 [3.00] diameter seal from
valve plate.
12. (A) Remove the valve drive.
Geroler
Applicable for displacement codes
Figure 6 (B) .
021, 025 and 040
10. (B) Remove the Valve Drive and Retaining Ring
11. (B) Remove valve plate and 76.0 [3.00] diameter seal
from valve plate
12. (B) Remove drive retainer
Seal
Figure 7 .
13. Remove the Geroler. Be sure to retain the rollers in
the outer ring if they are loose.
14. Remove the drive.
6
2000 SerieS diSc valve geroler motor
Seal
Valve Plate
Valve
Valve
Drive
Plate
Drive
Retainer
Retaining
Ring
Seal
Seal Geroler
15. Remove the 76,0 [3.00] diameter seal from
wear plate, see Figure 7.
Bearing
Housing
16. Remove the wear plate.
17. Remove the shaft face seal from the wear plate.
18. Remove the 76,0 [3.00] diameter seal from
bearing housing.
Bearing
Housing
19. You may need a press to remove shaft and bearing
assembly from bearing housing. (Key must be
removed before removing shaft.)
Bearing Housing
Exclusion
Seal
20. Use a small screwdriver to remove shaft seal,
back-up washer and exclusion seal from bearing
housing, see Figure 10. Do not damage bore of
housing.
N Noee: Individual parts of shaft and bearing assembly are not
sold separately. Replace as a unit.
C-MOLO-TM010-E1 June 2018 www.eaton.com
Seal
Shaft Face Seal
Figure 8 .
Figure 9 .
Shaft Seal
Back-up Washer
Figure 10 .
Wear
Plate
Shaft and
Bearing
Assembly