Tools Required For Disassembly - Eaton Char-Lynn 2000 Series Parts And Repair Manual

2000 Series Disc Valve Motors

Tools required for disassembly

and reassembly.
Torque wrench 57Nm [500 lb-in] capacity
300-450 [12-16]* breaker bar
9/16 socket
Small screwdriver 150-200 x 6,5 [6-8 x 1/4] blade
3/16 Allen wrench
Press
Approx. 13,0 [.50]
8,0 [.312]
4
2000 SerieS diSc valve geroler motor
Alignment studs (2)
9,5 [.375] Dia. Steel Rod
Grind at spots on each side
* Unless indicated otherwise, measurements
are given in mm [inches]
** Shaft seal installation tool (600496)
** Bullet (600465) for 1 diameter shafts
The following tools are not necessary for
disassembly and reassembly, but are
extremely helpful. Alignment studs (2)
200,0 [8.00]
25,0 [1.00]
C-MOLO-TM010-E1 June 2018 www.eaton.com
3/8-24 UNF thread