CyberData 011311 Operation Manual page 45

2. On the Network page, enter values for the parameters indicated in
Note
Web Page Item
Stored Network Settings
Addressing Mode
Hostname
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
Current Network Settings
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
VLAN Settings
VLAN ID (0-4095)
VLAN Priority (0-7)
Operations Guide
The question mark icon (
after the Toggle Help button is pressed
Table 2-9. Network Configuration Parameters
931645A
Installing the Singlewire InformaCast Office Ringer
Connecting an Auxiliary RGB Strobe to the Device
) in the following table shows which web page items will be defined
.
Description
Select either DHCP IP Addressing or Static Addressing by marking
the appropriate radio button. DHCP Addressing mode is enabled on
default and the device will attempt to resolve network addressing with
the local DHCP server upon boot. If DHCP Addressing fails, the
device will revert to the last known IP address or the factory default
address if no prior DHCP lease was established. See
"Factory Default Settings" for factory default settings. Be sure to click
Save and Reboot to store changes when configuring a Static
address.
This is the hostname provided by the DHCP server. See the DHCP/
DNS server documentation for more information. Enter up to 64
characters.
Enter the Static IPv4 network address in dotted decimal notation.
Enter the Subnet Mask in dotted decimal notation.
Enter the Default Gateway IPv4 address in dotted decimal notation.
Enter the primary DNS Server IPv4 address in dotted decimal
notation.
Enter the secondary DNS Server IPv4 address in dotted decimal
notation.
Shows the current network settings.
Shows the current Static IP address.
Shows the current Subnet Mask address.
Shows the current Default Gateway address.
Shows the current DNS Server 1 address.
Shows the current DNS Server 2 address.
Specify the IEEE 802.1Q VLAN ID number. Enter up to 4 digits. A
value of 0 disables vlan.
Note: The device supports 802.1Q VLAN tagging support. The
switch port connected to the device will need to be in "trunking mode"
for the VLAN tags to propagate.
Specify the IEEE 802.1p VLAN priority level. Enter 1 digit. A value of
0 may cause the VLAN ID tag to be ignored.
Click the Save button to save your configuration settings.
Click on the Reboot button to reboot the system.
Table 2-9.
Section 2.4.1,
CyberData Corporation
37