Adjusting The Office Ringer Volume - CyberData 011311 Operation Manual

2.3.3.2 Restoring the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Note
To restore the factory default settings:
1. Press and hold the RTFM button (see SW1 in
2. The device announces that it is restoring the factory default settings.
Note

2.3.4 Adjusting the Office Ringer Volume

You can adjust the Office Ringer volume through the
and
Operations Guide
Each Office Ringer is delivered with factory set default values.
The device will use DHCP to obtain the new IP address (DHCP-assigned address or default
to 10.10.10.10 if a DHCP server is not present).
Sensor Volume settings on the
Installing the Singlewire InformaCast Office Ringer
Connecting an Auxiliary RGB Strobe to the Device
Figure
Figure 2-15. RTFM Button (SW1)
SIP Volume,
Device Configuration
931645A
2-15) for more than five seconds.
RTFM button (SW1)
Multicast Volume,
Page.
CyberData Corporation
23
Ring Volume,