LAMINOX Idro TERMOBOILER Mini Series Instructions For Installation, Use And Maintenance Manual page 3

Dear Customer, Thank you for choosing one of our products, which is a result of technological expertise and
our continuous quest for superior products in terms of safety, reliability and performance. This manual
contains all the information and helpful tips for using your product with maximum safety and efficiency.
This manual has been prepared by the manufacturer and is an integral and essential part of the
product. In the event of sale or transfer of the product, always ensure the presence of the manual
as the information it contains is addressed to the buyer and to all those various people involved in
the installation, use and maintenance of the product. Carefully read the instructions and information
contained in this manual before installation, operation and maintenance of the product. The
instructions contained in this instruction manual guarantee the safety of persons and property and
ensure efficient operation and a longer service life. The manufacturer declines all responsibility for
damage caused by failure to observe instructions regarding installation, use and maintenance
listed in the instruction manual, for unauthorised modifications or non-original replacement parts.
Product installation and use must be carried out in accordance with the manufacturer's instructions
and in compliance with European, national and local regulations. Installation, electrical connection,
functional testing, maintenance and repairs are operations that must be performed by qualified and
licensed personnel who must have appropriate knowledge of the product. Product installation must
not be carried out close to walls made of wood or combustible material. For proper installation, you
must observe the "Safety distances" section. Verify the exact flatness of the floor where you will
install the product. When handling the steel parts of the cladding, use clean cotton gloves to
prevent leaving fingerprints difficult to remove for the first cleaning. Boiler installation must be
performed by at least two people. Connect the boiler to the mains only after proper professional
connection to the chimney flue. The power cable plug must remain accessible after installation of
the boiler. Only operate the boiler with regulation wood pellets (refer to the "FUEL" chapter). Never
use liquid fuels to operate the pellet boiler or to stoke the embers present. Provide adequate
ventilation in the installation area during operation. In the presence of operation failures, fuel supply
will be interrupted. Re-start the unit after removing the cause of the failure. Discontinue use of the
product in the event of failure or malfunction. Do not remove the safety guard located in the pellet
tank. Any accumulated unburned pellets in the burner as a result of repeated failed ignitions must
be removed prior to ignition. Pellet stove operation can cause very hot heating of the handles, the
chimney flue and glass surfaces. Only touch these parts during operation when wearing protective
clothing or with adequate aids. Because of the creation of heat on the glass, make sure that no
persons unfamiliar with boiler operation stand in the installation area. Inform children of the
precautions to be observed during product operation and of possible dangers. In the event of
problems or misunderstanding of the instructions manual, contact the dealer. Placing objects which
cannot withstand heat on the boiler or within the minimum required safety range is prohibited. Do
not open the door during operation or operate the boiler with its glass broken. For product terms,
limitations and exclusions, please refer to the warranty included with the product. In order to pursue
a policy of constant product development and renewal, the manufacturer may make changes to it
as deems appropriate without notice. This document is the property of the manufacturer and
cannot be disclosed in whole or in part to any third party without the written consent of the
company, which reserves all rights according to the law.
All our products are manufactured according to
the following guidelines:
89/366 EEC
2004/108 EC
2006/95 EC
89/106 EEC
IMPORTANT INFORMATION
GUIDELINES AND STANDARDS
In compliance with the following standards:
EN 60335-1; EN 60335-2-102
EN 61000-3-2; EN 61000-3-3
EN 50366; EN 55014-1; 55014-2
UNI EN 303-5-2012
3