General Notes; Assembly; Unpacking; Electrical Connection - LAMINOX Idro TERMOBOILER Mini Series Instructions For Installation, Use And Maintenance Manual

5.1

General notes

Here are some general recommendations to follow in order to prevent accidents or damage to the
product:
• Unpacking and installation must be performed by at least two people.
• All handling operations must be carried out using appropriate means and in full compliance with
safety regulations.
• The positioning of the packed product must be maintained in accordance with the guidelines
supplied by pictograms and written on the packaging.
• If using ropes, straps, chains, etc., make sure they are suitable for the weight to be unloaded
and are in good condition.
• When moving the package, move with slow and continuous movements to avoid tearing the
ropes, chains, etc.
• Do not tilt excessively in order to avoid overturning.
• Do not stand within range of the loading/unloading means (forklifts, cranes, etc.).
5.2

Unpacking

Unpack the product being careful not to damage or scratch it. Remove the accessory package and
any pieces of polystyrene or cardboard used to block removable parts, etc. from the boiler furnace.
Also remember not to leave packaging components (plastic bags, polystyrene, etc.) within the
reach of children, as they could be potential sources of danger. Dispose of them according to
regulations.
5.3

Electrical connection

The boiler is supplied with a power cable that must be plugged into a 230V 50Hz outlet.
Outlet connection in the rear of the boiler is illustrated in Figure 14.
Absorbed power is indicated in the "SPECIFICATIONS AND TECHNICAL DATA" chapter of this
manual.
By law, the system must be properly grounded and with a differential circuit-breaker.
Make sure that the electrical power cable does not come into contact with hot parts when set in its
final position.
CAUTION: ensure that the plug for electrical connection remains accessible after boiler
installation.
5

ASSEMBLY

1. External sensor clamp
2. Manual reset
3. Main switch
4. Power socket
Fig. 14
19