Iot Hardware - AMPLIFIED ENGINEERING fatbox G3 Manual

WEB
MANAGEMENT
FATBOX_G3
MENU OPTIONS
3. 9

IOT HARDWARE

Quick Start
LAN Settings
WiFi & BT Settings
WAN Settings
Port Forwarding
Dynamic DNS
IPsec VPN
Port Settings
IoT Hardware
IoT Client
SNMP
Management
System Status
Logout
HARDWARE :: Setting
Modbus mode [iotasset.pdf]
Disabled
CAN bus mode [iotasset.pdf] Disabled
Disabled
Zigbee mode [iotasset.pdf]
Repeated Values
Event Drop Type
secs
Poll Period
Poll Time Out
secs
Query Pause
secs (pause between query required for Modbus)
eg +8 or -6.5 (offset from UTC+0)
Time Stamp Offset
UPDATE
ODB2/Request/ Query mode
Auto Reporting: Read mode
fatbox G3
Choose 'Modbus Master' to send request
packet & read response value from the slaves
Choose 'Query mode' to send request
packet & read response values. Choose
'Read mode' when slaves auto report their
status/values
When you choose 'Repeated Values', you
will only send data to the cloud when there
are changes from the previous read value.
Select the time interval of reading data/
events of the iotasset listing. If you wish
have a different polling periods for
different assets, you can set it in your
iotasset.txt configuration file. Refer to our
iotasset.txt configuration guide or web
FAQ for detailed instructions.
The timeout specifies the time period to
accept responses after each network
request. The timeout setting must be
adequate for the network, taking into
account network traffic and network
latency. Inadequate timeout settings can
cause communication failures
If you require a pause between seperate
poll queries set it here
Set your local timezone for event
timestamp
Update and reboot FATBOX.