Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Aeotec Recessed Door Sensor 7
Summary of Contents for Aeotec Recessed Door Sensor 7
- Page 1 AEOTEC Engineering Specification Recessed Door Sensor 7...
- Page 2 This document mainly introduces the new generation AEOTEC Recessed Door Sensor. The content mainly includes its interfaces, accessories, features, specifications, quick start, and software function definition. Recessed Door Sensor 7 is a Z-Wave Plus v2 device with many advantages . Can be embedded inside t he wooden door or window.
- Page 3 AEOTEC Engineering Specification REVISION RECORD Version Date Brief description of changes 2019.07.24 First revision.
-
Page 4: Table Of Contents
AEOTEC Engineering Specification Table of Content INTERFACES & ACCESSORIES ............................1 FEATURES & SPECIFICATIONS ............................2 Structural Characteristics ............................... 2 Hardware Characteristics .............................. 2 Software Characteristics ..............................2 PRODUCT QUICK START..............................4 Important safety information ............................4 Optimally placing the product ............................4 How to install the product ............................. -
Page 5: Interfaces & Accessories
AEOTEC Engineering Specification 1 INTERFACES & ACCESSORIES Terminology Description Action Button Inside the Z-Wave Button Hole. Used for networking and resetting. Used for indicating the current state of the product. Magnet Change the sensor state via making the Magnet away or near. -
Page 6: Features & Specifications
AEOTEC Engineering Specification 2 FEATURES & SPECIFICATIONS Structural Characteristics Parameter Value Product Identifier ZW187 Dimensions Main Sensor: Φ19.2×64mm Magnet Sensor: Φ22×13mm Weight Color White Shell Material Shell Fire-proof Level UL94 V-0 Waterproof and Dustproof Rated IP20 under IEC 60529 Usage For indoor use. - Page 7 AEOTEC Engineering Specification Security Class Non-Security, S0, S2 Unauthenticated, and S2 Authenticated SmartStart Compatible Support. After powering on, SmartStart is auto activ ated if it ’s out of the Z-Wave network. Over The Air (OTA) Support. Firmware can be updated via RF.
-
Page 8: Product Quick Start
Recessed Door Sensor 7 is intended for indoor use in dry locations only. Do not use in damp, moist, and /or wet locations. Contains small parts; keep away from children. -
Page 9: How To Install The Product
AEOTEC Engineering Specification How to install the product The following extra things are needed for the installation: screwdriver, 19mm wide drill bit, drill driver, PVA glue, rubber hammer. 1. Drill a hole 65mm / 2.56inch deep in your door at the selected location with a 19mm / 0.75inch wide drill bit. - Page 10 Then press Recessed Door Sensor 7's Action Button once, its red LED will flash Red color. 5. When Recessed Door Sensor 7 successfully joins your Z-Wave network its LED will turn solid red for 10 seconds. If LED becomes slow fade-in fade-out Red color before turning off, it means the device is still unable to join your Z-Wave network;...
-
Page 11: How To Remove The Product From Z-Wave Network
AEOTEC Engineering Specification How to remove the product from Z-Wave network 1. Set your Z-Wave Controller into its 'Remove Device' mode in order to remove the product from your Z-Wave system. Refer to the Controller's manual if you are unsure of how to perform this step.