Aeotec ZWA005 Manual

Used in this guide.
Important safety information.
Please read this and the electronic guide(s) at
to follow the recommendations set forth by Aeotec Limited may be dangerous or cause a violation of
the law. The manufacturer, importer, distributor, and / or reseller will not be held responsible for any
loss or damage resulting from not following any instructions in this guide or in other materials.
TriSensor is intended for use in dry locations only. Do not use in damp, moist, and / or wet locations.
Contains small parts; keep away from children.
Quick start.
The following will step you through installing TriSensor and connecting it to your Z-Wave network.
1. Select an installation location for TriSensor. The sensor uses light and heat readings to detect
motion, so avoid pointing it at sources of both. Tips on optimising the installation location of
TriSensor can be found online in its digital guide.
2. Remove the backplate from TriSensor.
3. Insert one CR123A batteries with the correct orientation.
4. Replace the backplate.
5. Set your Z-Wave gateway into its 'add device' mode in order to connect TriSensor to your Z-
Wave system. Refer to the gateway's manual if you are unsure of how to perform this step.
6. inclusion in network:
Press once TriSensor's Action Button,If it is the first installation., the yellow LED will keep
solid until whole network processing is complete. If successful, the LED will flash white -> green ->
white -> green ,After 2 seconds have finished.If fail, the yellow LED lasts for 30 seconds, then the
green LED flashes once.
If it is the S2 encryption network, please enter the first 5 digits of DSK, and the location of
DSK is shown in the figure1.
7. exclusion out network:
Press once TriSensor's Action Button, the Purple LED will keep solid until whole network
processing is complete.if the exclusion is successful, the LED will flash white -> green ->white ->
TriSensor
ZWA005
http://support.aeotec.com/trisensor carefully. The failure