Nikon Eclipse E600W Instructions Manual page 15

4
Assembly for the multi-viewing model by 5 persons
1 Check that the serial numbers on the two components (on the main section and the
2 Adjust the height of the support stand so that the main observer section and the
3 When mounting the attachment on the inverted microscopes TE300 and TE200, the TE-
ND filter (φ28 mm)
Secondary
observer
section
[Remarks]
If a trinocular eyepiece tube T is used for the main observer section, you can provide the image to the vertical
tube of the eyepiece tube by setting the optical path to the "BINO & PHOTO" position. If the ND filter is
removed in advance from the eyepiece tube mounting port of the MTH main splitter, the main and the secondary
observers will be able to view an image with more uniform brightness. This should be convenient such as when
performing the TV observation.
14
relay section) of the MTH relay unit are identical. (If the numbers are different,
observation will be adversely affected. In this case, please contact your dealer or
nearest Nikon representative.) Two sets of MTH relay units are required. Assemble
those components with identical serial numbers to each other.
secondary observer section are horizontal. This step is facilitated by first adjusting the
support stand to an approximate height before attaching the stand.
TI intermediate eyepiece tube and E400/600 eyepiece tube are required. Attach the TE-
TI intermediate eyepiece tube instead of the original eyepiece tube and mount the MTH
main splitter on it.
See the illustration on P.12 for the installation of the TE-TI intermediate eyepiece tube.
5
4
Clamp for 5
3
Main observer section
Ensure that the
pointer mounting
surface faces
the front.
Assemble in the same
manner as that for
the right side.
1
Check that the
serial numbers
are the same.
MTH main splitter
MTH relay unit
Clamp for 7
7
Place
horizontally
9
Clamp for 3
MTH relay unit
2
Main section
Upper surface
should also be
horizontal.
Clamp for 9
Secondary
8
observer section
Clamp for 8
6
Height adjustment
clamp screw
Adjust to an
approximate height
and readjust later.