Before You Start; Product Compliance; Safety Information - Salus Quantum SQ610RF Manual

Introduction
The SQ610RF Quantum is a ZigBee temperature controller for wireless control of iT600 series devices, such as
the KL08RF wiring centre, mini TRV head, RX10RF boiler control module.
In order to control SQ610RF over the Internet or via the SALUS Smart Home mobile app (ONLINE mode), it
must be installed together with the UGE600 Internet gateway (sold separately). From the application level, it is
possible to pair SQ610RF with other system elements, e.g. Smart Plug SPE600, Smart Relay SR600 or window/
door sensor OS600/SW600.
SQ610RF can be used locally without an Internet connection (OFFLINE mode), however, it's communication
with other devices must be done using the CO10RF coordinator (sold separately).
The full PDF version of the manual instruction can be found at www.salus-controls.com

Product Compliance

This product complies with the essential requirements and other relevant provisions of Directives 2014/30/ EU,
2014/35/EU, 2014/53/EU and 2011/65/EU. The full text of the EU Declaration of Conformity is available at the
following internet address: www.saluslegal.com.

Safety Information

Use in accordance to national and EU regulations. Use the device as intended, keeping it in dry condition. Product for
indoor use only. Installation must be carried out by a qualified person in accordance to national and EU regulations.
Disconnect your equipment before cleaning it with a dry cloth.
Package Content:
1) SQ610RF Quantum Thermostat
2) Wall mounting plate
3) Self-adhesive mounting tape
4) Mounting screws
5) Manual instruction
2

Before you start:

New SQ610RF Quantum Thermostat is partially
1
charged, however, we recommend you to fully
charge the battery before use.
Connect charger to micro-USB Port which is at
the bottom of SQ610RF Quantum Thermostat to
charge the device.
Charging to full battery level may take up to
24h maximum.
Mounting: to mount thermostat you can use
3
included accesories (mounting screws or self-
adhesive tape). Remove back cover to mount the
plate to the wall. After this just attach thermostat
to the plate (it has built-in magnet).
Please note:
The ideal position to thermostat mounting is about
1,5m under floor level far from heating or cooling
sources. Thermostat can't be exposed to sunlight
or any extreme conditions like for example draft.
Wiring diagram (S1, S2 Input)
2
S1
S2
S
T
Symbols explanation:
S – volt-free contact
T – temperature sensor
S1,S2 Terminals:
- air or floor temperature sensor
- external volt-free contact to connect any ON/
OFF switch or occupancy sensor (Hotel card)
3