JUKI LK-1910 Engineer's Manual page 71

(16) Setting of F1 . F2 keys
Function No. : 023
Item : 1 Setting of F1 key
-1
1 to 999
Indication
Item : 2 Setting of F2 key
-1
1 to 999
Indication
(17) Setting of the stopping position of main shaft
Function No. : 027
Item : 2 Setting of the upper position or the upper dead point stop
UDET
Indication
AUDET
Item : 3 Setting of the holding mode of the servo-motor at the stopping position of the main shaft : This
function is not used with the standard machine.
OFF
Indication
ON
ALWAYS
Function : Setting of F1 and F2 keys on the operation panel can be made.
This function can set the keys which are used often during inputting.
[Contents] Not registered.
[Contents] Register the desired function No.
The function No. is the "Function No. described in the instruction
manual. : Initial setting 2
[Contents] Not registered
[Contents] Register the desired function No.
The function No. is the "Function No." described in the instruction
manual . : Initial setting 25
Function : This function selects whether the main shaft is stopped at the upper dead
point of the needle UP in the reverse rotation or the upper position.
[Contents] Main shaft stops at the upper position. : Initial setting
[Contents] Main shaft stops at the upper dead point.
[Contents] Holding control is not performed. : Initial setting
[Contents] Holding control is performed. (Excluding main body input mode)
[Contents] Holding control is always performed.
66
− −
(Set level 1)
(Set level 1)
(Set level 1)
(Set level 1)