How To Use The Inverting Clamp Device - JUKI LK-1910 Engineer's Manual

2) How to use the inverting clamp device

1. When using the inverting clamp device, it is required to change the mode to the inverting clamp mode
with the memory switch. (Refer to Instruction Manual for LK-1910 / 20.)
(1) When creating the pattern, be careful about the contact of clamp shaft with needle.
(2) Minimum size of the label is lateral 24 mm x longitudinal 16 mm.
In addition, there are several sizes of installing base as shown in the table.
Installing base
Dimension A
[mm]
5
6
7 D430121XB00
8
9
10 D431421YF00
(3) Thickness of cloth including label should be 4.6
mm or less. If the thickness is 4.6 mm or more, it is
dangerous since crank shaft coms in contact with
needle when jump feed is performed.
Standard Adjustment
10 mm or more
2nd origin
B
A
Installing base
B=20 mm
D431421WJ0B
D431421WZ00
D431421WK00
B4314210000
−
Crank shaft
B=24 mm
When dimension A is used below
10 mm, process the top end of
crank shaft to make it shorten.
Standard
(4) When using wiper, use the lateral sweeping type
one.
B21012200A0
Wiper asm.
M90605920A0
Lateral sweeping wiper relay
cable asm.
129
−