TANK INSTALLATION
Apply Teflon tape to the Tank outlet threads.
About 6-8 wraps will be sufficient. Figure 10.
Install the tank valve by turning it clockwise.
Tightening it hand tight is usually adequate but
additional tightening may be required.
Figure 11.
Once the valve is installed, connect the green
3/8" tubing to the tank valve. Figure 12.
NOTE: Tanks are pre-pressurized at 7 psi. Prior to installation, check, add or release as required.
Need help? 1.800.608.87.92
Indianapolis, IN | USA
FIGURE 10
FIGURE 11
FIGURE 12
www.uswatersystems.com
14