Contrast Adjustment (Contrast); Back Light Settings (Dimmer); Buzzer Settings (Buzzer) - JRC NCR-333 Instruction Manual

I
6.3.3.1 Contrast adjustment (CONTRAST)
1. CONTRAS When is selected, CONTRAST is ready to be entered. To adjust the contrast, press the
~ ~
key, and then press the IEN1j key.
I
' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' '(Q ' ' ' ' I
1.CONTRAST :
t
' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' '
''''
The adjustment of the contrast
- M1" is the darkest.
- M13• is the lightest.
The initial setting is "7·.
I
6.3.3.2 Back light settings (DIMMER)
Brightness can be changed into four levels (MAXIMUM, TYPICAL, MINIMUM and OFF) by pressing the IDIMI
key. These brightness levels are set up in this item.
The increase value of the brightness at the time of alarm generating can be changed from +1 to +9.
Select
~.J•MIM#].
and press the IEN1j key. Cursor moves to the right side of ":R.
Number and brightness is changed when
the~~
key is pressed, and then press the IEN1j key.
Press the IEN1j key after setting up to "ALERT". All setting values are saved.
· ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' '
' '
.
' '
.
' '
.
' '
. .
' '
.
' '
.
'
. .
'
. .
'
. .
' '
..
'
2.DIMMER
MAXIMUM
TYPICAL
MINIMUM
ALERT
m
8
4
+2
tr==="' ' • '· ' · ' · '· '· ' · ' · '· ' · '· '· ' · ' · '· ' · ' · '· ' · ' · '· ' · ' · '· ' · ' · '· ' · ' · '· ' · ' · '· '
I(
Notes Jl
• MMAXIMUM" should enter the largest numerical value and "MINIMUM" should enter the smallest
numerical value.
• When not connect to the BAM, "ALERT' is displayed instead of MALARM·.
I
6.3.3.3 Buzzer settings (BUZZER)
When - is selected, each buzzer functions can be set enable (ON) or disable (OFF) as followings.
Press the • ..-key and select the "ON" or "OFF".
Press the EN key after setting up to "CLICK''. All buzzer settings are saved.
'''' ' '' ' '' ' '' ' '' ' '' ' '' ' ' ~ ' ' '' ' ''
3. BUZZER :
~
ALERT MSG : OFF
(FOR MESSAGE TYPE:A,B,L)
RECEIVED MSG ON
BAM ALERT : OFF
CLICK : ON
ON:
OFF:
A buzzer is sounded.
A buzzer is not sounded.
, , , , , , , , , , , , , , ,, , ,, , ,, , ,, , ,, , ,, ,,
OFF: All buzzer functions are disabled. BUZZER:
-ALERT MSG:
ON: Each buzzer function as shown below can be enabled.
When a message (A, Band L) is received.
-RECEIVED MSG:
-BAM ALERT
-CLICK:
I(
Caution Jl
When a message (other than A, Band L) is received.
When a failure alarm occurs.
When a key is pressed.
When search and rescue message (D) is received, buzzer sounds. The SAR buzzer sound can not be
set to "OFF (disable)".
6-39