Power Supply Cable Removal - Epson Perfection 3200 Photo Service Manual

EPSON Perfection 3200 Photo

4.2.11 Power Supply Cable Removal

1. Release the carriage lock. (See Section 4.2.1.)
2. Remove the document cover. (See Section 4.2.2.)
3. Remove the upper cover. (See Section 4.2.3.)
4. Remove the three screws (CBS, M3x5), and the disconnect the lock-type
connector (CN1) from the power supply circuit board. (See Figure 4-34)
5. Remove the power supply cable cover. (See Figure 4-34)
6. Disengage the two hooks, and then remove the power supply cable unit.
(See Figure 4-35)
When securing the power supply cable unit, secure the
Cover Cover Inlet with the same screws.
Attach the power supply cable cover to the lower housing
with double-sided tape.
Disassembly and Assembly
Power Supply Cable
Power Supply Cable
DISASSEMBLY AND ASSEMBLY
Cover Cover Inlet
Cover
CBB Screws (3x12)
Tightening Torque : 6-8kgfcm
Figure 4-34. Power Supply Cable Removal (1)
Hooks
Figure 4-35. Power Supply Cable Removal (2)
Revision A
Connector
Power Supply Cable
48