Section 8 - Troubleshooting; Description Of Faults With All Handpieces - InMode System with BodyFX Handpiece Operator's Manual

Section 8 – Troubleshooting
The InMode System provides monitoring of all critical parameters to ensure safety of
patient and user. If any of the following faults are detected system automatically goes to
STAND BY mode.

Description of Faults with All Handpieces

System did not turn on
 Check power cord connection
 Check that main switch on rear panel is on
 Check fuses on back panel of the System
 Call Technical Service if problem persists
Software plug missing
 The software plug is not inserted
Checksum
 The software was not loaded properly from software plug
 Check plug connection and reboot the System
 Call Technical Service if problem persists
Fault H8002 - Handpiece is not connected
 Check connection of Handpiece
 Replace Handpiece
 Call Technical Service if problem persists
Fault H8005 – System Memory Fault
 Call Technical Service if problem persists
Fault H8601 – Distributor Card Connection Fault
 Call Technical Service if problem persists
Fault H8609 – Water Temperature Fault
 Call Technical Service if problem persists
Fault H860B – Water Flow Fault
 Call Technical Service if problem persists
Laser Related Faults - H8003, H8006, H8007
 Call Technical Service if problem persists
InMode BodyFX Operator Manual 35