NAPCO iSecure ISEC-WL-KEYPAD Operating Manual page 22

E04-(89-92) -- Wireless Siren Trouble
Supervisory
A problem has been detected with a
wireless siren. Call installing compa-
ny for service.
E04-(93-96) -- Wireless Takeover Mod-
ule Trouble Supervisory
A problem has been detected with a
takeover module. Call installing com-
pany for service.
E05-(83-88) -- Wireless Keypad Trou-
ble Low Battery
E05-(89-92) -- Wireless Siren Trouble
Low Battery
E05-(93-96) -- Wireless Takeover Mod-
ule Trouble Low Battery
The battery in a wireless device is
low and should be replaced. The
replacement battery for the ISEC-WL
-KEYPAD is CR123A (use one for
standard battery life, use two for ex-
22
S Y S T E M T R O U B L E E R R O R C O D E S ( c o n t ' d )
tended battery life). The siren re-
quires 4 alkaline C-size batteries. If a
low battery is indicated for a takeover
module, check the battery or power
supply that is providing power to the
module. Warning: Replace batteries
only with the same type as specified
above. Use of other types may pre-
sent a risk of fire or explosion. Never
recharge or disassemble a battery, or
dispose of in fire.
E06-NN -- Receiver Response Failure
Call installing company for service.
E09-00 -- System Cold Start
For installer use only. (This indica-
tion always appears when a system
"Cold Start" is performed. "Cold
Starting" the Go-Anywhere Smart
Hub resets it back to its original
"default" condition, i.e. the state it
was in when it left the factory).
E10-NNN -- Keypad Response Failure
Call installing company for service.
E11-NNN -- Keypad Tamper
The Go-Anywhere Smart Hub has
been opened, or a wall-mounted key-
pad has been opened and/or re-
moved from the wall. Call installing
company for service if problem can-
not be repaired.
E15-NNN -- RF Transmitter Tamper
Wireless transmitter cover removed
(NN = transmitter number). Call in-
stalling company for service.
E16-NNN -- Wireless Receiver Jam
A problem has been detected with
the wireless receiver. Call installing
company for service.
(continued)