Table of Contents
Advertisement
T U R N I N G O F F T H E A L A R M ( D I S A R M I N G ) W H E N R E T U R N I N G
Disarming the System
1. Enter your premises through the entry/exit door. The keypad will sound a steady tone to remind you to disarm the
system before your entry delay time expires.
2. Enter your User Code and press ENTER. The word "READY" will appear to indicate the system has been disarmed.
If you enter an invalid User Code, the keypad will beep 4 times, signifying an error. Re-enter your User Code
immediately. Note: 10 seconds before the entry delay expires, the keypad will emit a pulsing warning tone.
Alarm Indication / Silencing an Alarm
Proceed with caution! If you suspect that an intruder may still be on the premises, leave immediately and call
authorities from a neighbor's telephone!
To silence an audible alarm:
1. Enter your User Code and press ENTER. After the system is disarmed, the Window will continue to display the
number(s) of the zone(s) violated.
2. To reset the Window display, note the zones violated, then press RESET.
Ambush
My Ambush Code is ___________________
If an intruder forces you to disarm your system, enter your Ambush Code and press ENTER. Using your Ambush Code will
send a silent alarm to the central station. The Ambush Code is a 2-digit code (prefix) entered just prior to your normal User
Code.
Example: If your User Code is 1 2 3 4 and your Ambush Code is 9 9, press 9 9 1 2 3 4 ENTER.
The red ARMED light will go out and the green STATUS light will turn on, as if the system were normally disarmed. The
system will appear to be disarmed normally, and there will be no indication that a special "silent" alarm has been sent to the
central station.
11
Advertisement
Table of Contents
