Configuring Upnp Tm Settings - HIKVISION DeepinMind iDS-6700NXI Series User Manual

Step 3 Configure the following Email settings:
Sender: The name of sender.
Sender's Address: The Email address of sender.
SMTP Server: The SMTP Server IP address or host name (e.g., smtp.263xmail.com).
SMTP Port: The SMTP port. The default TCP/IP port used for SMTP is 25.
Enable SSL: Click the checkbox to enable SSL if required by the SMTP server. When the SSL is
enabled, the default TCP/IP port used for SMTP is 465.
Attached Image: Check the checkbox of Attached Image if you want to send email with attached
alarm images.
Interval: The interval refers to the time between two actions of sending attached pictures.
Authentication (optional): If your mail server requires authentication, check this checkbox to use
authentication to log in to this server and enter the login User Name and Password.
The Receiver table: Select the receiver to which the email is sent. Up to 3 receivers can be
configured.
Receiver: The name of user to be notified.
Receiver's Address: The Email address of user to be notified.
Step 4 Click Save.
Please refer to the following sections for more information:
Configure alarm linking methods with Send Email on Chapter 7.1.1 Configuring Motion Detection,
Chapter 7.1.2 Configuring Alarm Input, Chapter 7.1.4 Configuring Video Loss Alarm, Chapter 7.1.5
Configuring Video Tempering Alarm and Chapter 7.1.6 Handling Exception.
4.3.6 Configuring UPnP
UPnP™ can permit the device seamlessly discover the presence of other network devices on the
network and establish functional network services for data sharing, communications, etc. If you
want to use the UPnP™ function to enable the fast connection of the device to the WAN via a
router, you should configure the UPnP™ parameters of the device.
Before you start:
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of
the router to which your device is connected. When the network working mode of the device is set
as multi-address, the Default Route of the device should be in the same network segment as that
of the LAN IP address of the router.
Step 1 Go to Configuration > Network > Basic Settings > NAT to enter the NAT settings page.
DeepinMind Series NVS User Manual
Settings
TM
37
iDS-67 00 Deep inMind Ser ies NVS User Manua l