Configuring Rs-232 Serial Port - HIKVISION DeepinMind iDS-6700NXI Series User Manual

If the device is connected to a public network, you should use a NTP server that has a time
synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44). If the device is set up in a more customized network, NTP software can be used to
establish a NTP server used for time synchronization.
 Configuring Time Synchronization Manually
Enable the Manual Time Sync. function and then click the
the pop-up calendar. You can click the
You can also check the checkbox of Sync. with computer time to synchronize the time with the
local PC.
 Check Enable DST to enable the DST function and set the date of the DST period.
Step 4 Click Save.

4.2.2 Configuring RS-232 Serial Port

The RS-232 serial port can be used in two ways:
 Parameters Configuration: Connect a computer to the camera through the serial port. Device
parameters can be configured by using software such as HyperTerminal. The serial port
parameters must be the same as the serial port parameters of the camera.
 Transparent Channel: Connect a serial device directly to the camera. The serial device will be
controlled remotely by the computer through the network.
Step 1 Go to Configuration> System > System Settings > RS-232.
Step 2 Configure the Baud Rate, Data Bit, Stop Bit, Parity, Flow Control, and Usage.
DeepinMind Series NVS User Manual
icon to quickly select the time.
Figure 4-4 Manual Time Sync.
Figure 1. 2
DST Settings
30
icon to set the system time from
iDS-67 00 Deep inMind Ser ies NVS User Manua l