Intended Use - Makita DPP200 Instruction Manual

Oblong punching
Punch
Unit: mm
Punch Die
6.5 x 10 6.5 x 10B
6.5 x 13 6.5 x 13B
8.5 x 13 8.5 x 13B
8.5 x 17 8.5 x 17B
9 x 13.5 9 x 13.5B
9 x 18 9 x 18B
10 x 15 10 x 15B
10 x 20 10 x 20B
11 x 16.5 11 x 16.5B
12 x 18 12 x 18B
13 x 19.5 13 x 19.5B
14 x 21 14 x 21B
Symbols
The followings show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
Flying debris and loud noise hazards. Wear
ear and eye protection.
Hazardous voltage. Disconnect all power
before working on this equipment. Failure
to observe this instruction may result in
death or personal injury.
Moving blade. Keep hands clear while
machine is operating. Turn power off
before servicing.
Die
Tensile
Mild Steel (65,000 psi)
t2 - t6
t2 - t6
t2 - t6
t2 - t6
t2 - t6
t2 - t6
t2 - t8
t2 - t8
t2 - t8
t2 - t8
t2 - t8
t2 - t8
Workpiece
Flat bar
Angle
Channel
Channel
-
-
-
-
-
-
t7.5
t7.5
t7.5
t7.5
t7.5
t7.5
Ni-MH
Li-ion

Intended use

This tool is intended for piercing a hole on steel
material.
8 ENGLISH
Capacity
Max: 80 mm x t8
(Center punching)
Min: 40 mm x 40 mm x t3
Max: 80 mm x 80 mm x t8
Min: 75 mm x 40 mm
Max: 100 mm x 50 mm
(Flange punching)
Tensile
Stainless Steel (89,000 psi)
t3 - t4
t3 - t4
t3 - t4
t3 - t4
t3 - t4
t3 - t4
t3 - t6
t3 - t6
t3 - t6
t3 - t6
t3 - t6
t3 - t6
Only for EU countries
Do not dispose of electric equipment or
battery pack together with household waste
material!
In observance of the European Directives,
on Waste Electric and Electronic
Equipment and Batteries and Accumulators
and Waste Batteries and Accumulators
and their implementation in accordance
with national laws, electric equipment and
batteries and battery pack(s) that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.