Cree CR Series Installation Instructions

IMPORTANT SAFETY INFORMATION

When using electrical equipment, basic safety precautions should always be followed including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant l'installation.
2. This luminaire must be installed in accordance with the NEC or your local electrical code. If you are not familiar with these codes
and requirements, consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique local. Si vous n'êtes pas familier avec ces codes et
ces exigences, veuillez contacter un électricien qualifié.
3. Access above ceiling required.
Accès requis au-dessus du plafond.
4. Do not handle energized module with wet hands or when standing on wet or damp surfaces, or in water.
5. Do not use this equipment for other than its intended use.
SAVE THESE INSTRUCTIONS FOR FUTURE

TO INSTALL:

1
3

STEP 1:

Remove screw from battery compartment. See Figure 1.

STEP 2:

Remove cover from battery compartment. See Figure 2.
1 of 2
REFERENCE

STEP 3:

Disconnect connector by depressing latch. See Figure 3.

STEP 4:

Remove existing battery and properly dispose of the battery per local
codes. See Figure 4.
LED Luminaire With Emergency Driver
2
4
CR Series
Includes: EB14 Driver Replacement
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
LPN00470X0001A0_A