Midea MTB1T-96CWN1 Technical & Service Manual page 110

Midea R410A T3 50Hz Top-discharge Series
Correct install the back cover and firmly buckle the front cover and back over, otherwise will
make the front cover drop off.
7. Wired remote controller initial parameter setting:

Change the related functions of the controller through adjusting the initial parameters.
 The wired controller initial parameter includes two codes "XY". The first code "X" means
the function class, the second code "Y" means detailed configuration of this function.

Setting method
Step1: Simultaneously press the mode button
Step2: The value of the first code "X" is "0", press the temperature setting buttons
Step3: After setting the second code value, press Quiet/OK button
Step4: When the first code value is "6", press Quiet/OK button
109
:
controller for 5 seconds to enter the parameter setting state.
to adjust the second code value.
code to the next value.
parameters setting.
MCAC-UTSM-201707
and fan speed button
again to exit the
of the wired
and
to switch the first