Midea MTB1T-96CWN1 Technical & Service Manual page 102

Midea R410A T3 50Hz Top-discharge Series
The setting method of timer off is the same as the timer on.
Under timer setting state, set the timer on and the timer off to be 0.0h can cancel timer on and
time off.
Note:
If the wired remote controller has been set timer on/off, press the ON/OFF to turn on or turn off
the unit then the timer will be canceled simultaneously.
7) Clock setting
Press the timer/clock button
status.
The hour position of the clock will flash, and can press
After finishing the hour setting, press left button
minute position setting, then the minute position will flash, press
minute value.
After finish the clock setting, press the
the setting state.
8) Quiet operation
Under COOL, HEAT, FAN modes, press the
used to reduce the running noise through setting the fan speed to low.
Note:
Under AUTO, DRY mode, the fan speed is auto and the
9) Lock the wired controller
Press the temperature adjusting buttons
enters into locking state, and the locking icon
Under the locking state, the wired remote controller will not respond to the buttons pressing and
the control instruction from the wireless remote controller.
101
setting for 3 seconds, and then enter into the clock setting
button or wait for 5 seconds to confirm and exit
button to set into the quiet operation, it is
and
will be lighted up.
MCAC-UTSM-201707
and to adjust the hour value.
or right button
and
button does not work.
simultaneously, the wired controller
to switch to
to adjust the