Replace A Route Processor Card - Cisco 8800 Series Hardware Installation Manual

Replace a Route Processor Card

Figure 47: Replace Air Filter
Step 2
Install the new door filters on both the front doors.
Step 3 Tighten the two quarter turn fasteners back on the doors.
Replace a Route Processor Card
The router supports up to two redundant Route Processor cards (8800-RP). When two Route Processor cards
are installed in the router, one acts as an active card and the other as the standby card. When the active Route
Processor card is removed, the router automatically makes the standby Route Processor card active. If the
router has only one Route Processor card that is installed, a new Route Processor can be installed in the empty
Route Processor slot during operation.
Warning Statement 1029 Blank Faceplates and Cover Panels
Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages
and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other
equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all
cards, faceplates, front covers, and rear covers are in place.
Hardware Installation Guide for Cisco 8800 Series Routers
86
Replace Chassis Components