Cisco 8800 Series Hardware Installation Manual page 40

Locate and Ground the Chassis
Figure 19: Ground the Chassis
1
2
3
Step 2 Use the wire stripper to strip one end of the 2-AWG wire approximately 0.75 inches (19.05 mm).
Step 3
Insert the 2-AWG wire into the wire receptacle on the grounding lug.
Step 4 Use the crimping tool to carefully crimp the wire receptacle around the wire; this step is required to ensure a
proper mechanical connection.
Step 5
Insert the two screws through the holes in the grounding lug. Ensure that the grounding lug does not interfere
with other router hardware components.
Step 6
Use the Phillips screwdriver to carefully tighten the screws to 60 in-lbs 6.7 (N-m) of torque until the grounding
lug is held firmly to the chassis. Do not overtighten the screws.
Step 7
Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an
adequate chassis ground.
What to do next
Attach the chassis doors.
Hardware Installation Guide for Cisco 8800 Series Routers
34
Locate ground
Prepare lug
Ground the chassis
Unpack and Install the Chassis
4 Align the lug holes
5 Tighten the screws