Attach The Optical Network Cable - Cisco 8800 Series Hardware Installation Manual

Hide thumbs Also See for 8800 Series:
Table of Contents

Advertisement

Attach the Optical Network Cable

Step 7
Holding the pull-tab, fully seat the transceiver in the module's transceiver socket until it clicks.
Attach the Optical Network Cable
Before you begin
Before you remove the dust plugs and make any optical connections, follow these guidelines:
• Keep the protective dust plugs installed in the unplugged fiber-optic cable connectors and in the transceiver
• Inspect and clean the MPO connector end faces just before you make any connections.
• Grasp the MPO connector only by the housing to plug or unplug a fiber-optic cable.
Note
The transceiver modules and fiber connectors are keyed to prevent incorrect insertion.
Note
The multiple-fiber push-on (MPO) connectors on the optical transceivers support network interface cables
with either physical contact (PC) or ultra-physical contact (UPC) flat polished face types. The MPO connectors
on the optical transceivers do not support network interface cables with an angle-polished contact (APC) face
type.
Note
Inspect the MPO connector for the correct cable type, cleanliness, and any damage. For complete information
on inspecting and cleaning fiber-optic connections, see the
Connections
Procedure
Step 1
Remove the dust plugs from the optical network interface cable MPO connectors and from the transceiver
module optical bores. Save the dust plugs for future use.
Step 2
Attach the network interface cable MPO connectors immediately to the transceiver module (see figure below).
Hardware Installation Guide for Cisco 8800 Series Routers
64
optical bores until you are ready to make a connection.
document.
Connect Router to the Network
Inspection and Cleaning Procedures for Fiber-Optic

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

881288088818

Table of Contents