Installing A Rear Door; Attaching Racks In A Suite - IBM Power Systems 7953-94X Installing

Hinge
pins
Figure 16. Removing a rear door
2. Holding the door firmly with one hand, lift both hinge pins until they lock in the open position. This
releases the door from the hinges.
3. Grasp the door firmly with both hands and pull it away from the hinges; then, set the door aside.

Installing a rear door

To install a rear door on the rack cabinet, complete the following steps:
1. Grasp the door firmly with both hands, align the door with the hinges, and slide the door into place.
2. Holding the door with one hand, push the hinge pins down to the closed position.

Attaching racks in a suite

Learn how to attach an expansion rack to a standard rack or another expansion rack.
1. Before you attach an expansion rack to a standard rack or another expansion rack, you must remove
the outriggers from the racks so that the racks fit together correctly.
2. You cannot install the front upper attachment bracket on the following rack models:
v 7953-94X with Feature Code EU21
v 7953-94Y with Feature Code EU21
3. For rack models 7953-94X and 7953-94Y with Feature Code EU21, when you attach racks together,
make sure that you leave the maximum gap allowed by the baying kit so there is ample door
clearance.
16
Installing the 7953-94X and 7965-94Y rack and features