Installing A 0U Pdu Vertically In The Rear Of A Rack Cabinet - IBM Power Systems 7953-94X Installing

M6 clip nuts
Figure 22. Installing a 1U PDU or console switch vertically in a rack side pocket
3. Carefully slide the PDU or console switch into the side pocket and secure the device with four M6
screws.

Installing a 0U PDU vertically in the rear of a rack cabinet

Learn to install a 0U power distribution unit vertically in the rear of a rack cabinet.
The following illustration shows one way to install a 0U PDU in the rear of the rack cabinet. You can
install up to four 0U PDUs vertically in the rack cabinet, depending on your rack configuration.
To install a 0U PDU vertically in the rear of a rack cabinet, orient the PDU vertically and insert the two
pegs on the PDU into the keyhole slots in the side of the rack cabinet (see the following illustration).
Push down to secure the PDU in position.
24
Installing the 7953-94X and 7965-94Y rack and features