Table of Contents
Advertisement
7.2.2
Tab. 64
7.3
Tab. 65
76
7
Initial Start-up
7.3
Checking installation and operating conditions
Special measures for recommissioning after storage
➤ Carry out the following before every start-up after long period of storage:
Storage
Remedy
period longer
than:
5 months
➤ Remove the desiccant from the openings in the air intake filters of the engine
and compressor.
➤ Check the air and oil filters.
➤ Drain the preserving oil from the separator tank.
➤ Fill with cooling oil.
➤ Drain the preserving oil from the engine.
➤ Fill with engine oil.
➤ Check the engine coolant
➤ Check the battery charge.
➤ Re-connect the battery (batteries).
➤ Check all fuel lines, engine oil lines and compressor cooling oil lines for leaks,
loose connections, wear and damage.
➤ Clean the bodywork with a grease and dirt dissolving agent.
➤ Check the tire pressures.
36 months
➤ Have the overall technical condition checked by an authorized KAESER service
representative.
Measures for recommissioning the compressor after a long period of storage
Checking installation and operating conditions
➤ Check and confirm all the items in the checklist before starting the machine.
Task
➤ Are the operators completely familiar with safety regulations?
➤ Have all the positioning conditions been fulfilled?
➤ Is there sufficient cooling oil in the separator tank?
➤ Is there sufficient oil in the engine?
➤ Is the maintenance indicator on the air intake filters (engine and
compressor) OK?
➤ Is there sufficient coolant in the coolant expansion tank?
➤ Is there sufficient fuel in the fuel tank?
➤ Is there sufficient tool oil in the tool lubricator? (Option ea, ec)
➤ Is there enough antifreeze in the frost protector? (Option ba)
➤ Are the access doors closed and all body panels in place?
➤ Are the tire pressures OK?
Installation conditions checklist
Operator Manual
Screw Compressor
M27
See chapter Confirmed?
–
5
10.4.1
10.3.4
10.3.2,
10.4.7
10.3.1
–
10.8.1
10.8.3
–
–
No.: 9_9548 05 USE
Advertisement
Table of Contents
