Remove The Front Cover, Control Board, And Power Supply - Janome QMP16SU Manual

Removing the Front Cover
Remove the three small front frame screws
Tools: 3 mm handle hex wrench; may need a 3
mm L-hex wrench to break loose the screws.
1. Unplug the machine.
2. Use the 3 mm hex wrench to remove the
three frame screws (circled).
Remove the thread mast
Tool: 3 mm handle hex wrench
1. Loosen and remove the two screws in the
thread mast.
2. Remove the thread mast.
Loosen or remove the three power plate screws
from the bottom of the front cover.
Tool: 2.5 mm handle hex wrench
1. Lift the machine and carefully lay it on its side
while taking care to not put pressure on or bend
the machine encoder.
2. Loosen or remove the three screws on the bottom
power plate from the front cover.
| 7
QMP16SU Service Manual