Janome QMP16SU Manual page 60

The following is the normal LED response if the front handlebars and optional rear handlebars are
disconnected from the the machine:
• Test 1 LED: is off
• Test 2 LED: is off if in manual mode or if in stitch regulation mode with handlebars disconnected.
• Test LED3 and Test LED4: Are both off (because there is no communication to the unplugged front
display
• Needle LED: Goes on and off as the hand wheel is rotated (on from needle lowest position until the
needle is up and the take-up lever is at its highest position; and off from when the take-up lever is just
60 |
www.Janome.com