Installation Precautions; Water Connection - VKI Technologies Eccellenza momentum Operation Manual

Installation Precautions

This equipment is designed for indoor use only and must never be installed
outdoors.
Avoid using extension cords and power bars when connecting this equipment
to a power source.
Installation of this equipment must comply with all local, state/provincial and
federal codes and regulations. It is the sole responsibility of the installer to
research and to comply with these codes and regulations.
This equipment must be installed on a dedicated 20 amp outlet. Do not
install other equipment on the same outlet/circuit.
Ensure that the equipment is level and stable. This is done by adjusting the
levelers (legs) at the bottom of the machine. Also, do not block any of the
equipment's ventilation ports.
Leave room at the rear of the equipment for the plumbing fitting and water
hose, as well as for adequate ventilation.
Leave ample room above the equipment to open and fill the product
hoppers.

Water Connection

Installation of this equipment must comply with all local, state/provincial
and federal codes and regulations. It is the sole responsibility of the installer
to research and to comply with these codes and regulations.
Accessibility to shut-off valve(s) must be provided and explained to customer
in the event water supply to brewing equipment must be shut off.
For multi-unit locations whereby the main water conduit is supplying water to
more than one unit (including water coolers), a separate in-line shut off valve
must be installed onto each individual equipment unit.
The Eccellenza Momentum is factory-equipped with an integrated backflow
prevention check valve. An additional external backflow prevention system is
not necessary.
VKI Publication #202377-001
Eccellenza Momentum
15