VKI Technologies Eccellenza momentum Operation Manual page 113

6. Remove the inner access panel at the top of the door (4 screws). This exposes several
wire-tie anchor points, onto which the card reader control module will be installed.
Secure the card reader module using wire-ties to at least two of the anchor point in the
7.
door. The installation location may vary depending on the model of card reader used.
8. Connect the 6-pin male MDB connector from the card reader, to the 6-pin female MDB
connector on the door wiring, and then install the magnetic antenna onto the metal
plate to the left of the control module.
VKI Publication #202377-001
Eccellenza Momentum
113