Panasonic DP-CL18 Service Manual page 204

DP-CL18
11.2.3. FSR Temp. Setting
1. To enter the "Service Mode", turn on the power. Turn on the power while pressing the
then keep pressing the
2. Press the Menu/Exit button, select "FSR Temp. Setting" by pressing
3. Select the media type by pressing
4. Set the value of FSR Temp. Setting by pressing the
approximately +1°C (-1°C) every +1 (-1). If the phenomenon as the example 1 happens, increase the fusing temperature by
pressing the button. If the phenomenon as the example 2 happens, decrease the fusing temperature by pressing the
button. When performing this adjustment, use the following test print pattern or user's unique test pattern.
5. Select "Temp. Test Prn.", press the Enter button, select the media needed the fine temperature adjustment, and then Enter
button to print. The color chart as shown in the following is printed. Check the print quality. If necessary, readjust.
and buttons until "Initializing" is displayed.
/ button, and Enter or continue button.
/ button, and Enter or continue button.
/ button. The fusing temperature increases (decreases) by
204
and buttons at the same time,