Panasonic DP-CL18 Service Manual page 129

1. Remove the CMY home lever, PC home spring and PC home
lever.
2. Remove the screw and OPC cam home position sensor
board.
1. Remove the 4 E-rings, 4 OPC Gears and 4 DEV. gear
assemblies.
Caution:
When exchanging the OPC Gears, the 4 OPC Gears must
be exchanged with new 4 gears with the same molding
number at the same time, or the poor printed quality may
be caused. Regarding to the molding number, the
molding number has been marked on the OPC Gear as
shown below (Figure-2).
2. Remove the fuser idle gear (1 E-ring).
129
DP-CL18