Panasonic DP-CL18 Service Manual page 126

DP-CL18
8.7.5.1. Inner Cover, ADU Jam Detection Sensor Board and ADU Detection Sensor
1. Remove the inner cover (2 screws).
2. Disconnect the 2 connectors from the inner cover.
3. Remove the fuser earth plate (1 screw).
4. If necessary, remove the ADU jam detection sensor board
and ADU detection sensor.
8.7.5.2. Main Drive Unit
1. Remove the 7 screws, securing the main drive unit.
2. If necessary, disconnect the 2 motor cables.
3. Separate the main drive unit from the chassis.
4. If necessary, disconnect the sensor cable from the main drive
unit.
Note: For easy re-installation of the main drive unit
When reinstalling the main drive unit, see the section
8.11 "Paper Feed Unit" and remove a clip and the
registration clutch from the paper feed unit.
After reinstalling the main drive unit, reinstalling the
registration clutch and a clip to the paper feed unit.
126