PIONEER DJ DJM-V10 Instruction Manual page 86

• Set [ATT.] to a setting between [–3dB] and [–12dB] in [MASTER OUT] in the [UTILITY]
settings.
For the channel input sound:
• Adjust the [TRIM] knob so the channel level indicator lights up with the peak level at around
[0] dB.
 The crossfader does not work.
• Check the [CROSSFADER ASSIGN (A, THRU, B)] selector switch is set properly.
Effects
 BEAT FX does not work.
• Make sure the [BEAT FX ASSIGN] button is lit for the channel you want to add the effect
to.
• Make sure the [FX FREQUENCY (HI, MID, LOW)] button is lit for the band you want to add
the effect to.
 SEND does not work.
• Make sure the [SEND] knob is set properly.
• Make sure any external FX unit connected to the [EXT1 SEND] and [EXT1 RETURN]
terminals, or the [EXT2 SEND] and [EXT2 RETURN] terminals, is plugged in properly.
 The SEND effect sound is not input to the master sound.
• Press the [MASTER MIX] button to turn on MASTER MIX.
• Make sure the [MASTER MIX LEVEL] knob in the [SEND] section is set properly.
 The SEND effect sound is not input to the channels.
• Set the input selector switch for the channel to [BUILT-IN], [EXT1], [EXT2], or [BUILT-IN,
EXT1, EXT2].
 An external FX unit connected to MULTI I/O does not work.
• Select a channel to add the effect to with the [CH SELECT] switch.
• Press the [ON/OFF] button in the [MULTI I/O] section to turn on MULTI I/O.
• Make sure an external FX unit is properly connected to the [MULTI I/O SEND] and [MULTI
I/O RETURN] terminals.
• Make sure mobile devices are properly connected to the mobile device connection terminal
(USB terminal). Launch the FX application on the mobile device.
Additional information
86