Motomaster ELIMINATOR 11-1586-4 Owner's Manual page 9

ASSEMBLY INSTRUCTIONS (cont'd)
1
A
x4
F
1
Attach the Foot – Remove the charger from
the packing materials and place upside down
on a flat surface. Attach the foot (1) and secure
it (2) with the four 1/4" – 20 thread cutting
screws provided.
3
2
E
1
J
Mount the Axle to the Charger – Place one
end of each bracket into the slot on the bottom
of the charger (1). Place the axle assembly
under each bracket (2). Rotate the brackets
horizontally (3). Attach the brackets using the
two 10" – 32 thread cutting screws provided (4).
J
2
3
2
1
4
C
2
D
I
1
I
G
Assemble the Wheels and Axle – Hold the
axle upright on the floor or work surface. Then,
using a hammer, tap one of the axle caps onto
the top end of the axle (1). Be sure to tap the
axle cap on straight. Slide both wheels onto the
axle (2) with the recessed hubs facing out as
shown. Install the second axle cap (3).
4
H
1
x4
B
Attach the Handle – If the charger came with
a plastic grip, slide that onto the handle until
it is centered at the top. Turn the charger right
side up onto its foot and wheels. Align the
handle screw holes with the screw holes on the
upper back corners of the charger (1). Attach
the handle using the four Phillips head screws
provided (2).
D
3
2
2 2
J
1
7